Suspended Solids Sensor Options

The Model 15 Suspended Solids Sensor incorporates near infrared technology, solid state electronics, and custom geometry.
- Our near infrared technology provides increased dependability of the reading when color changes in the solids occur.
- The solid state electronics increases consistency of the reading and reliable digital communications up to 2000ft.
- Our custom geometry optimizes the sensor for its measurement range and facilitates the integrated jet clean.

Our continuous SS sensors come standard with tool free 1/4" O. D. tubing connectors for the integrated jet clean and 33ft (10m) of sensor communications cable. Additional cable length is available upon request.

Below are the available sensor options.
——————————————————————————————————

 

Model 15
The Model 15 Sensor is our standard mount. This model features all of the above with a
PVC 1-1/2" NPT male mounting thread.
For: MLSS - RAS - WAS

 

Model 15L
The Model 15L Sensor is designed to measure very low solids concentrations typically found in secondary clarifier and plant effluents. This model has a PVC 1-1/2" NPT male mounting thread.
For: CLARIFIER & PLANT EFFLUENT

 

Model 15PI
The Model 15PI Sensor is intended for in line monitoring in a large diameter pipe . The mount is 2" NPT male thread in 316 stainless steel that works with a customer supplied
2" weld-a-let. The integrated jet clean, with this sensor, includes an inline check valve. There is a flow indication groove on the back of the sensor mount, that should be parallel with the flow.
For: RAS - WAS

Model 15T
The Model 10T Sensor is intended for sample by-pass lines of mixed liquor, return, or waste activated sludge. The by-pass loop is generally configured using customer supplied full port ball valves on both sides of the tee. The supplied tee (as shown) is 3" Schedule 80 PVC, with female slip connections. The integrated jet clean with this sensor includes an inline check valve. There is a flow indication groove on the back of the sensor mount, that should be parallel with the flow.
For: MLSS - RAS - WAS

 

 
Model 17
The Model 17 Sensor combines the ease of use of a hot tap mount with the reliability of the InsiteIG SS Sensor.
The mount is a 2" NPT male thread in 316 stainless steel that works with a customer supplied
2" weld-a-let, saddle or existing piping. The integrated jet clean includes an inline check valve.
For: RAS -WAS

Model 17 Manual (3613 KB)